Speedfeed Drills
The Speedfeed drill is a twin fluted, carbide tipped coolant fed drill. The micro grain solid carbide tip is multi regrindable. The tubular shank is formed and heat treated from high quality chrome molybdenum steel into an overlapping figure of eight cross section.
The maximum flute length is 900mm subject to the application being suitable. Please discuss new applications with Hammond & Company's technical department.
A regrinding service is available at our Hemel Hempstead factory.
- Tungsten Carbide tipped
- Multi-regrindable
- 5,0 to 30,0 diameter
- High penetration rates
- Good size control and surface finish
Ordering Information
When ordering Speedfeed drills please state diameter, flute length and driver design. Alternatively, go towards the end of this website and order by Product Codes. Product Codes.
Driver Styles |
|||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||
Speedfeed Cutting Data |
|||||||||||||||||||||||||||||||||||||||||||||||
|